Velcro Gun Holsters, Flat Back Velcro Holster

This holster has a flat back lined with Velcro and is designed to be mounted to a hard surface like furniture or inside a vehicle. It can also be attached with hardware. The holster includes the hook side (the rough side) attached to the back of the holster and a loose sheet of adhesive-backed loop (soft side). FEATURES: Zero cant angle. Sight channel is tall enough to accommodate any aftermarket sights. Open bottom. 0.80 thick kydex. Attach to any surface that you can attach soft side Velcro to. Rivets hold the 2 halves of the holster together so it can be mounted to a hard surface by fasteners as well. Made in the USA! WHAT DRAW DO YOU NEED? Picture this holster as though you are wearing the flat side against your body. If that is how you are going to need it positioned
Functional & fun women's holsters, concealed-carry purses, range gear, shooting accessories & gifts - customizable! Articles and information for women shooters.
This holster has a flat back lined with Velcro and is designed to be mounted to a hard surface like furniture or inside a vehicle. It can also be attached with hardware. The holster includes the hook side (the rough side) attached to the back of the holster and a loose sheet of adhesive-backed loop (soft side). FEATURES: Zero cant angle. Sight channel is tall enough to accommodate any aftermarket sights. Open bottom. 0.80 thick kydex. Attach to any surface that you can attach soft side Velcro to. Rivets hold the 2 halves of the holster together so it can be mounted to a hard surface by fasteners as well. Made in the USA! WHAT DRAW DO YOU NEED? Picture this holster as though you are wearing the flat side against your body. If that is how you are going to need it positioned for your draw, eg. inside a jacket pocket on your strong side or on the inside of a vehicle center console that you can draw from the driver's side, then you would need to order the same draw as if you were wearing it on your waistband, ie. order your strong-side draw. If you are going to attach this holster to a surface away from your body, or facing your body, then mimic or visualize your draw from that position, to figure out where the grip will end up and which side you need the velcro on. Some applications would need an opposite side draw than what you'd get if it was on your body - eg. attached on the outside of a vehicle center console on the drivers side (as shown in the main product pic). With the gun inserted, a right-hand draw flat-back holster will have the velcro (flat side) on the gun's left side. A left-hand draw holster will have the velcro (flat side) on the gun's right side. Ask us if you need guidance on this. A NOTE ABOUT RETENTION: Because of the construction of the holster, there is no adjustable retention or audible snap retention. This is impossible when one side of the holster is flat, rather than molded around the gun. There is some retention, you just can't tip the holster upside down, shake it and expect the gun to stay in the holster. So this holster is best suited for hard surfaces or applications where it will remain upright. Some customers do use this holster inside bags and packs, we just want you to be aware of the way the retention is impacted by the flat-back design, so that you can make a good decision about which product is best for you. For retention that keeps the gun in the holster even when tipped upside down, take a look at the Adhesive Velcro Quick-Ship Holster instead. That ships with loose hook and loop velcro sheets, so you can attach as needed. It also has a lot less kydex material (since it's not designed to be mounted to a surface), so it's better suited for use in bags, packs or pockets.